Most of these pictures were taken my last day at the Mack I Plant

My last day at the Mack I Plant

Joseph Bletch (in yellow shirt) operated the polisher, washer and the pin and plugger. Towanda Kimbrough was the operator for the left side OP10, OP20's and OP30's Raymond Elmell (with beard) was the operator for the right side OP10, OP20's and OP30's Lewis Merrwether was the OP80 off-load operator.

This is Scott Sabisch checking the cams.

Tony Davis was one of our many foremen

Gene Simpkins was the pipefitter for the Cam and Head Assembly Department

Tom Groff was the millwright for Cams and Head Assembly Department.

David Poma (left) was the Toolmaker for the Cams Department Ken _____ was Toolmaker for the Head Assembly Dept.

Petko Tomovski was the electrician repair for left Head Assembly Dept.

Roger Johns was the machine repair for the Cams & Head Assembly Dept.

Joe Lumley was the electrician for the right Head Assembly Dept.

LaTrice checking the cams to see if they meet Specifications LaTrice M Shaw had been hired as a foreman before I left.

If we made more Cams than the Head Assembly could use, the cams were stored....or if we were down, cams could be put back into the system

The Bingo Board for the Cams Dept.

This is William (Bill) Jetter one of our many foremen

This was where I keep my toolbox and cabinet in the Cams Department

This was where I did my homework while going to Baker College

TSX-57 Maintenance Training April, 1999

Charles Bullock, Richard Hagen, Mark Trautman, Kenneth Graham and Dino Chatzis

Charles and Richard

Charles, Richard, Mark, Kenneth and Dino

Mark, Dino and Kenneth